                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3111672
Deathvigil Stricke Pattern Rhinoceros/Wild Hog by Kalrath is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

Stricke Pattern Rhinoceros/Wild Hog

For the older chaps, this was also based on Clouseau's Pattern

Side Doors should be compatible with Standard Doors.
Side Doors and Main Top Hatches have slots for Magnets

The Turrets are from theavatar111, just changed up a bit to fit this design.
https://www.thingiverse.com/theavatar111

The Command and Auxiliary Hatches and tracks are based on Woddish's awesome PzKpfw 
https://www.thingiverse.com/woddish

WARNING!
There are small gaps between the side/back doors and the hull. You'll need to join them in order to print it whole.



Enjoy and support the plastic kit makers.

If you like my models, consider leaving a tip! :)



WiP: Will eventually add options for other vehicles, but I think standard Versions will fit, as well as the hatches.
Will need to revise the Track file. Once printed it is a few mm too short.

Edit 23/09/18:
Uploaded Headlights and the Hull with Headlights attached.
Also uploaded a version of the hull with the tracks attached.
Increased the Wall thickness of the turret ring mount.
Reduced Poly count on the hull
Increased gaps for the hatches and doors.
Thanks to KarnageKing for the input! https://www.thingiverse.com/KarnageKing/about

Edit 26/10/18:
Changed the Split Tracks a bit to remove intersecting bits with the body
Changed the Lascannon Turret and split the cover
Added an Assault Cannon