                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:3004288
Ciber Space Transport Prepped for Print by HammerofHeaven is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

This is the complete transport with all the parts broken up for printing. I am part way though printing this myself. I will add a couple of versions set up for SLA printing where needed. To print this I highly recommend using a combo of FDM and SLA printing.

If you do not have an SLA printer, then you may be better off not printing the dudes inside or the seat assembly.

If you do not print the seat assembly, then you can place a model with a 25 mm base in that slot.

Down the line, I may try to add a version of the guns which are easier to print with FDM.

I will also remix this into its big gun version.

Print the following:
 1x Front
5x Ribs
10x Flayers (SLA strongly recommended)
10x Spine Mount With Terminator (Or just the spine mount, the spine mount should print with FDM, if you include the dude, then I recommend SLA)
1x Cockpit Core
1x Cockpit Cap
1x Cockpit Spine (SLA recommended, you may want to omit this part otherwise)
1x Left Hand Small Armor Plate
1x Right Hand Small Armor Plate
1x Left Hand Long Armor Plate
1x Right Hand Long Armor Plate
1x Seat Assembly with Pilot (SLA recommended, if you do not print this part, you can put a model with a 25 mm base in its place.)

Tips:
Asseble with CA glue. 
Print slow and cold.
Use filler primer on the FDM parts.

If there are any problems or missing parts let me know!

Update: Heavy Cannon available here:
https://www.thingiverse.com/thing:3006232