                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:3006249
Ciber Space Terminator Heavy Artillery Cannon by HammerofHeaven is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

This is the complete artillery piece with all the parts broken up for printing. I will add a couple of versions set up for SLA printing where needed. To print this I highly recommend using a combo of FDM and SLA printing.

If you do not have an SLA printer, then you may be better off not printing the seat assembly.

If you do not print the seat assembly, then you can place a model with a 25 mm base in that slot.

Down the line, I may try to add a version of the guns which are easier to print with FDM.

There is also the troop transport version available, you should be able to find it in the remix section.

Print the following:
1x Front
5x Ribs
10x Flayers (SLA strongly recommended)
1x Cockpit Core
1x Death Cannon
1x Cockpit Spine (SLA recommended, you may want to omit this part otherwise)
1x Left Hand Small Armor Plate
1x Right Hand Small Armor Plate
1x Left Hand Long Armor Plate
1x Right Hand Long Armor Plate
1x Seat Assembly with Pilot (SLA recommended, if you do not print this part, you can put a model with a 25 mm base in its place.)

Tips:
Assemble with CA glue.
Print slow and cold.
Use filler primer on the FDM parts.

If there are any problems or missing parts let me know!