                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3654944
Eagle Shrine for Warhammer 40K by Walkyrie222 is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

Basicaly, a remix of BiancaW's model of the Shrine of the Aquila (by the way : great job BiancaW ! Thanks for all your uploads of GW-like buildings !)

I sliced the walls to save filament but also to glue them on other structures to improve them.
You've got an old piece of scenery that doesn't look that good ? Well, just pimp it by adding some pieces of walls, buttresses, tiled floors and so on !

I don't intend to post a guide because some pieces are very specific to the pre-existing elements I had, but if you examine closely every element, I'm sure you'll figure out how to use them, and better, how to modify them to fit and improve your own sceneries ;)

I also included some benches made by mr_mich : https://www.thingiverse.com/thing:2613324 (note that I didn't remixed them : just used them as they are !)

# Print Settings

Printer Brand: Prusa
Printer: Prusa Mk2
Rafts: No
Supports: No
Resolution: 0.2 but 0.1 should be great !
Infill: 10% to 20% square

Notes: 
For better results, set the first layer no more than 0.2 mm (I set mine at 0.4 and the result is quite rough because the wall itself is no more than 0.4mm thick ! So It is only made out of one layer... Better 2 or 3 layers for a smoother result)