                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:1985375
15mm Zone Mortalis Board by printalotapotamus is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

I created a Zone Mortalis type board for my 15mm Gruntz Spec Ops games. Print multiple copies of each piece and then you can rearrange them however you like to make maps with twists and turns that are different each time.

Inspiration came from this blog post:
http://standwargaming.blogspot.com/2015/08/homemade-zone-mortalis-board.html

I plan on printing 4 or more of each type. They take around 3 hours to print (at 0.15mm layer height) so this may take a while before I have them done. I will post pictures when they are completed.

If you like the work I'm doing and would like to contribute, you can do so at [my Patreon page](https://www.patreon.com/smokalotapotamus).

# Print Settings

Rafts: No
Supports: No
Resolution: 0.15mm
Infill: 12%