                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


http://www.thingiverse.com/thing:3580855
Tower Mausoleum - Resin Friendly by Uglyduckling81 is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

A quick remix of jimbeanz fancy dice tower.
https://www.thingiverse.com/thing:3577456

Scaled it to fit on a Anycubic Photon build plate.
Changed it a little bit to just be a Mausoleum instead of a dice tower.

I hollowed the base and top. I tried to hollow the main wall panels but it kept crashing meshmixer.

I included both Hollow and Unhollowed depending on your preference.

You will need to print 4 of the spikes and 2 of the base (hollow or not). Don't mirror the base section, just print 2 the same. The way they are sliced will have sculptures lined up if you do.

It stands 245mm Tall When Assembled.

I can't print it myself as my Photon's LCD is not functioning correctly, so I'm in printing Limbo until a new one arrives. I was working on this for my next print, so I thought I might as well share it anyway.

Good Luck