                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2940285
Industrial Dome Expansion Set 2  by SevenUnited is licensed under the Creative Commons - Attribution - Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/

# Summary

<b>Please note that the Dome and one of the bodys showed in the pictures can be found here:</b>
https://www.thingiverse.com/thing:1561986
_______________
(2018-06-02)
Updated the industrial_ladder_top.stl file it was minimal to wide to fit in the flat_top.
If you had already printed the ladder_top you can as fix you just cut the edge of the flat_top where the ladder should go.
_______________
Here comes the second expansion for the Industrial Dome

I made a Flat top piece and a modular ladder to get on top. The ladder is designed to print multiple parts to reach higher grounds.
The control panel piece is meant to go at the outer shell of the lower part of the Dome.
The Funnel piece goes on top of the Round dome this was Remixed from.
I split it into 3 Parts for better printability.

I add pictures after i printed everyting.
_______________
<b>Also have a look at my other expansion sets for the Industrial Dome:</b>
https://www.thingiverse.com/thing:2927639 Set 1
https://www.thingiverse.com/thing:2943417 Set 3
https://www.thingiverse.com/thing:3011075 Set 4
______________
Here are the parts this originated from:
https://www.thingiverse.com/thing:1561986
______________
An not to forget where the original Industrial Dome came from:
https://www.thingiverse.com/thing:1147117