                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:3020503
Imperial Industrial Support Beams by theavatar111 is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

# Summary

Hold up your walk ways with these gothic styled support beams. They come with 3.5mm holes that should fit into any 4mm hole or 4mm Hex mount that you might just happen to already have. 

If you don't have any already, check out Imperial Walkways https://www.thingiverse.com/thing:2991954  and print some to go with.

Combine to create industrial structures to battle over in the so far grim dark future.

So far parts are provided fully assembled, intended to print upright. I'll be posting split versions soon that can be mirrored. If you can't wait until then, Lay flat and lower Type 1 or 2 by 9mm or type 3 by 9.2mm to get a perfect half. Repeat for the second half and mirror by X.


Note that previous versions where too weak when printed upright. This version has been fortified and blessed by the Omnisia but yet to be tested by the minions at Imperial Manufacturium Division XXI.